Anti-Ran (RAN, TC4, ARA24, RAN, member RAS oncogene family)

RAN (ras-related nuclear protein) is a small GTP binding protein belonging to the RAS superfamily that is essential for the translocation of RNA and proteins through the nuclear pore complex. The RAN protein is also involved in control of DNA synthesis and cell cycle progression. Nuclear localization of RAN requires the presence of regulator of chromosome condensation 1 (RCC1). Mutations in RAN disrupt DNA synthesis. Because of its many functions, it is likely that RAN interacts with several other proteins. RAN regulates formation and organization of the microtubule network independently of its role in the nucleus-cytosol exchange of macromolecules. RAN could be a key signaling molecule regulating microtubule polymerization during mitosis. RCC1 generates a high local concentration of RAN-GTP around chromatin which, in turn, induces the local nucleation of microtubules. RAN is an androgen receptor (AR) coactivator that binds differentially with different lengths of polyglutamine within the androgen receptor. Polyglutamine repeat expansion in the AR is linked to Kennedy's disease (X-linked spinal and bulbar muscular atrophy). RAN coactivation of the AR diminishes with polyglutamine expansion within the AR, and this weak coactivation may lead to partial androgen insensitivity during the development of Kennedy's disease. Applications: Suitable for use in ELISA, Western Blot. Other applications not tested. Recommended Dilution: Peptide ELISA: 1:32,000, Western Blot: 0.3-1ug/ml, ~25kD band observed in lysates of cell lines A431, HeLa, HepG2 and NIH3T3 (calculated MW of 24.4kD according to NP_006316.1), Optimal dilutions to be determined by the researcher. Storage and Stability: May be stored at 4°C for short-term only. For long-term storage and to avoid repeated freezing and thawing, aliquot and store at -20°C. Aliquots are stable for at least 12 months at -20°C. For maximum recovery of product, centrifuge the original vial after thawing and prior to removing the cap. Further dilutions can be made in assay buffer. Peptide Blocking: Corresponding peptide is available for Peptide Blocking studies. See R1069-01A-P. Antibody is typically 0.5mg/ml and peptide is supplied as a 100ul pellet. When peptide is reconstituted in 200ul water, the concentration would also be 0.5mg/ml. To start, the best ratio would be 1:1 (molar excess of peptide relative to antibody when identical volumes are mixed). Mix equal volumes of peptide and antibody at the required dilution and leave at ambient temperature. It is best is to have two identical blots to be incubated with equal amount of antibody, but one with the antibody pre-adsorbed to the peptide for 20min. Then incubate and develop the two blots in parallel.